Camera Pan and Tilt Kit

Description

This is a stand alone pan/tilt FPV module that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher.  A full 360 degree pan (+/- 180 degrees) is possible with the addition of a servo stretcher or extended pwm signals

The modules are supplied with standard 9g servos by default.  For better resistance to crash damage, and for better tolerance of 900MHz video systems, HS-65HB servos are available as an upgrade option. 

Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation. 

The module can be attached to the plane of your choice with four screws. Dimensions listed in the pictures.

Comes with a solid uncut mounting plate that will fit many popular FPV cameras, not the open backplate shown in the image.

Note: Currently the back plates are designed for the pan/tilt system being installed on top of the aircraft.  If you plan on mounting the assembly inverted under the aircraft, some modifications to the back plate may be required. 

This kit includes:

• Laser cut components and required hardware for pan/tilt module
• Two budget 9g Servos (choices in options)
• Solid Backplate (not OSD open type as seen in the product pic)

Note: for the “no servo” option, it is up to the customer to modify the assembly if required.  The system was designed for the servo options listed.  Any other servo must be aligned properly for proper gear engagement.

Servo Stretcher Note: The HS65 servos might not perform well with a servo stretcher. Other options are okay.

You’ll need to supply:

• Double sided servo tape to retain camera and tilt servo.
• Pull-ties to hold TX against tape and for holding your wiring down.
• Medium CA
• 5 minute epoxy

Manual: Pan/Tilt Module